ATI graphics

Rick Colombo (colombo@fnal.gov)
Mon, 06 Dec 1999 14:58:49 -0600

I'm trying to configure a new Gateway PC w/ Linux 5.2.1 and I can't get
the graphics to work. If I choose "unlisted card" and "generic
multisync", the screen comes up blank (leaving me dead in the water).
If I choose an ATI device, it fails and says "None of the configured
devices were detected". The board has "Rage 128" written on it and I
have tried all the ATI/Rage drivers, but nothing works. Is there
another ATI selection that will work or do I have to wait 6 months and
hope someone writes a device driver?

--
Rick Colombo@fnal.gov - Home Page: http://www-oss.fnal.gov/~colombo/
'87 Bronco "Bucking Fronco" 302EFI, AOD, Ford 9"/4.11/LSD, 35"BFG-AT/KO
Registry: http://www.thewowfactor.com/bigbroncos/detail.cfm?detailid=175